Broken Hot Water Heater: Use Essential Tip to Protect Your Water Heater from Breakage

The water heater tends to be more reliable especially in the winter season. It is necessary to maintain you’re this appliance regularly to use it for long period of time. There are a number of things that you need to consider in maintaining your heater. 

The anode rod in your Hot Water Heater needs to be replaced at particular interval of time. There is great chance to get sediment deposits at the bottom of the tank and cause popping sounds when the burners ignite. The users require draining out these sediments regularly. The thermostat needs to be checked regularly to conform whether it is working properly or not. A broken dip tube as well can result in the incoming cold water bring mixed with the outgoing hot water. There is also the chance of uncontrolled thermal expansion. The only solution to escape from all these problems is regular checking and maintenance.

A breakage in your hot water appliance require a well-experienced plumber. However, maintaining your hot water tank annually can help you in saving both time and money. Some other times, it requires you to replace your heater.

Hot Water Repair Maintenance Tips
 
Prepare the water heater - Try to turn off the power if it is not in use and if you are using a water heater at your home. Open a hot water tap inside the house. Air pressure will come out of the tap. Open the drain valve located at the bottom of the water heater. Make sure your house members are not going to turn on the heater when maintenance is going on.

Remove sediment by dissolving it – The most effective way to dissolve sediments is only by using a descaler called Mag-Erad. If you are using this first time then don’t mind to use the instruction that come with the descaler. Never on the water heater without water in it as it can cause heavy damage. You can also use lye to dissolve sediment. Make sure these are done only by professionals.

Regular check water heater plumbing fittings – It is necessary to check the Broken Hot Water Heater for any possible leaks. The loose valve and the drain valve can leak. The thermostat controls for both gas water heaters and electric water heaters can also leak. The gas control has the words ON/OFF/PILOT written on it, so use it whenever necessary and stop any leakage.

Steel connections – If you are having a steel touches copper or brass in the water heater then there is more chance to occur rust. It is very effective to use a steel nipple with a plastic lining in your heater.

Broken nipples – There is more chance of breakage of nipples when you try to remove it with a pipe wrench, grab a flat-end screwdriver and a hammer. It is good idea to use the screw driver to pry up the broken nipple. Install the new nipple wrapping it with teflon tap on the threads.